Assembly Will Mesh But Not Run

I've got a simple solid aluminum structure mounted to a plate. The design is new and the geometry is subject to change. The structure supports a swinging pendulum used for shock testing. I excluded the arm from the assembly and put a load on the shaft holes to simulate the force from the pendulum. I have defined my contacts, applied a simple fixture to the bottom of the base plate to simulate it being mounted to a table or floor. The assembly will mesh but will not attempt to run. I get a warning saying that "one or more loads/contacts/fixtures are invalid". Yeah that really helps SW.

Check out the doc attached

Any thoughts?

Thanks.

Nate

SolidworksSimulation
Answers 13
SF
SF 2013-11-15 Best Answer

any chance that one of them is a beam?

can you post the meshed version?

can you post the model?

SF
SF 2013-11-15

Hey Jared,

How and where can I post the assembly?

SF
SF 2013-11-15

pack and go the assy

top right hhand corner "use advanced editor" to post

SF
SF 2013-11-15

Here you go Jared

SF
SF 2013-11-15

what do you want to have happen to arm 1?

it isn't bonded to anything, it has a bearing connector to the pin but the arm has no restraints, so a little inbalance and it will fly off into space > solver error

SF
SF 2013-11-15

Jared thanks for looking at it,

Ultimately I would like to see how much stress and displacement will occure when:

1. The arm (with a mass on the end not shown) hits a rigid surface at the bottom of the stroke

2. The stress and displacement on the members from the swinging mass.

SF
SF 2013-11-16

those are nonlinear dynamic studies

for a static analysis put the force on the pin for now

SF
SF 2013-11-18

Jared,

So I have excluded the arm and bearings and just left the pin. I put a force on the pin but I still get the window saying "one or more loads/contacts/fixtures are invalid". I applied the fixture to the bottom of the plate.

SF
SF 2013-11-18

post the model.

normal troubleshooting at this point is to limit the number of things in your model and figure out what you eliminate that fixes it.

SF
SF 2013-11-19

Jared,

I have excluded the arm, bearings, and smaller base plates. I just mated the legs to the baseplate for simplicity. I applied a 300 N load on the pin and manually made the contact sets on the components. I got it to run a few times but with unusable results. Have a look see.

Thanks

Nate

SF
SF 2013-11-19

File was too large. Let me zip it again.

SF
SF 2013-11-20

Jared,

I got it to run. I wiped out everything from the assembly including mates (which were corrupted). Suppressed the base plate, arm, and bearings and just fixed the bottoms of the members.

Thanks for help

Nate

SF
SF 2013-11-20

weird. mates shouldn't have any effect on simulation.