Analysis Example Needed - Static vs Modal

I'm trying to explain (to upper management and other lay persons) why it is important to understand a structures response modes versus just performing a linear static analysis with assumed load magnitudes for evaluating current product problems as well as future new designs.  I am trying to layout a "structural analysis and test roadmap" for our organization - where we are and where we need to go.  (I will then use this to justify better software (Sim Prem & better workstation) !!

What I would like to have is a basic example of a situation where the highest strain energy location in a modal analysis is not the same location as the high stress point(s) in a static load analysis (for same boundary conditions).  I know, lots of assumptions here!  Unfortunately I only have Sim basic and cannot even do modal analysis right now.

I have scoured the internent and not found a good basic example.  Anyone have something I could use to help explain some of these intricacies and why its important to understand both?

Thanks in Advance,

T

SolidworksSimulation