I am simulating the superplastic forming using Abaqus built-in pressure algorithm following this example(https://www.sharcnet.ca/Software/Abaqus/6.14.2/v6.14/books/exa/default.htm?startat=ch01s03aex34.html).

As my Die geometry is different so I face the following error(bold italiac) in the message file.

"The current loading appears to be producing a too large maximum equivalent creep strain rate(ratio:4.3624)The incremnet will be attempted agian with the new amplitude"

So after doing 3 to 4 cut off in the pressure my simulation stops.

My query is that is there any way through which this pressure cut off trial can be increased or nay way to define 2 solution dependent amplitudes because I have tried many things but i am continuously getting this error.