Subroutine runs and complete but not provide results

Hi,


I am trying to run a a subroutine in abaqus in a very simple axsisymetrical model (0.1 x 0.2 m) with a sigma 1 and sigma 3 pressure. However, when the simulation completes, I cannot find any results. When I go to odb. visualization results, it appears a message ´´Deformation and/or analytical surface extent is too large as compared with the model´´.


I have already changed the deformation scale factor to 1, checked the unit of the variables too many times, boundary conditions, and decreased the load magnitude, but the problem still happens. Do you have any idea what is going on with this situation? 


Thank you!