Abaqus - Temperature of the Model is not changing in an AM Model!?

Hello dear Expertise, 
I have modeled a simple coating model with AM plug in. The process is cold spray coating.
I was successful to create event series for heat source and material addition. Now moving of heat source and element activation works properly but the problem is that even with a high amount of heat flux, the temperature of the components don’t go up. It remain at initial temperature (32 degree). 
What I have done is as bellow:


In AM Plugin:
I have defined a Uniform heat source
Set Power in event series = 90e9 J/sm3 (I have considered it Heat flux; Am I right?)
Absorption Coeff. = 1
Material Deposition Process= Bead
Deposition position= above
Defined Heating, Cooling and Material Arrival in Simulation Setup of AM plugin


In Model Tree:
I have defined two model: Heat Transfer model and Static model
I have not defined Convection, Radiation and Load module in none of the Heat transfer and Static Models (only I have set these parameters in AM Plugin).
Create Tie Constraint in both model (Tie Coating to the substrate)
Define Initial temperature for coating and substrate= 32 degree (for both Heat Transfer and Static models)

Does anyone know what is my mistake and why the temperature of the coating and substrate won’t change from their initial temperature even with a body heat flux(or power?) of 90e9 J/sm3?

Thank you in advance.

Zohreh

Abaqus ​​​​​​​