Hi all! I am running an Abaqus/Explicit simulation with both contact (tangential + normal behavior), and cohesive surface interaction (cohesive behavior + damage). I am putting all of these parameters in the same contact property, and then defining a general contact interaction. When I submit the job, I get a warning that cohesive behavior cannot be used for General contact (see screenshot attached). However, the job then runs exactly as intended, while it should not according to the warning.
The strange and annoying thing about all of this is the following: the analysis runs just fine on Abaqus/CAE 2023 (Windows), but gets aborted with no explanations whatsoever when running the job on Abaqus/CAE 2023 (Linux); no errors in the .dat/.log or .sta files, etc., it just stops abruptly after writing the .sta file. The same thing happens if I submit it through the command line or by importing the .inp file. I use this Abaqus/CAE Linux installation daily with no issues so this should not be an issue with the particular version I am using, but rather with the job itself.
Do you have any idea about what could be happening here? I'd be happy to share the .inp file in private if that helps. Thanks!