Hi everyone,

We are facing an issue with transferring part mass from Autodesk Inventor to the 3DEXPERIENCE platform using the Power'By connector.

Current Setup: We use an Inventor iLogic script to write the part mass into a Custom iProperty, which is then mapped to 3DEXPERIENCE via CAD Collaboration settings.

The Issue: This setup only works partially. It fails on certain parts where we get errors or wrong values. We suspect the issue is low mass, as it breaks specifically on very small or light parts.

Question:

• Is there a simpler/more elegant/another way to map mass directly? Is there direct CAD Collaboration setting to link the mass to 3DX (like \\\$\\\$description\\\$\\\$)?

Any help would be appreciated!

Thanks.