DraftSight worked for many months, after previously dealing with a rare problem nobody knew how to fix, and this morning the computer was shut down directly from the power button (force shut down) and not by my hand. When the computer started back up, it still runs just fine butr then i was receiving an error message when i try to run DraftSight. Unfortunately i removed the program and re-installed in hopes of combating the issue, but now it still will not start and i no longer see the error message, only that a crash report is being generated. I need some help trying to figure out exactly how i can get this program running again for we are in the process of trying to bring over our 20,000 drawings into SolidWorks 2014. As of right now, we are as good as being down in this department. Any feedback is welcome.

Thank you,

Joseph Smith