In the attached image, I have a drawing with two Sections(A-A& B-B). The section line for B-B is made up of 5 lines sothatit cuts through the center of multiple fasteners. As you cansee inthe image, the section line gives me errors. I have alsoattachedan image of what the section is meant to look like. Itswitchesback and forth between the error and being fine whenI'mediting other areas of the drawing. I have to either rebuildtheview or open the assembly and then go back to the drawing tobringit back to normal. Any help? Thanks.SolidworksDrawings And Detailing








