I have a part (imported from the manufacturers website) in my assembly that keeps going to a transparent mode on it's own. The icon does not indicate that it should be transparent, and when I force it to go transparent, it stays transparent. The head scratcher is that when I then force it to show again, it becomes un-transparent. Then I save the assembly, close it, an open it again...the same part is now transparent. I've done this process numerous times, and I don't know what the problem is....even after opening the part file and making sure that it is not in transparency mode.
Does anyone else experience anomalies like this? SolidworksAssemblies
Does anyone else experience anomalies like this? SolidworksAssemblies

My coworker had something similar to this with transparency andcolors switching. I think he was on Sp0 at the time though. I thinkhe's had these issues resolved in sp3.
I have personally had a file or two that wouldn't go transparentusing the context icon via right-click. I actually had to do it theold way and go through component properties.
Don
CSWP
I also had a part disappear visually from the assembly but I couldview it in the part file. I tried the show/hide command as well astransparency command. Neither worked. The part still showed up as afactor when I tried to calculate the mass properties. I could alsoedit each sketch and feature in the assembly but when I exit theediting feature the part would disappear again.
Henry
CSWP
It happened with my Old Workstation (Dell PWS670 with FX3450)
and it still happens on my new station (See Sig)
it only happens to me when i'm working in assemblies with Subs..
Main level parts don't do it, just parts that are in Sub's that are2 or 3 tiers deep..