Hello all,
Is there a guide anywhere which explains the steps required to do atoolbox install on a network drive? I want to set a completefastenerlibrary that all the engineers, as well as the shopforeman, can have access to. I know that I have seen somethingsomewhere, but cannot recall where. Any information would beappreciated.
Chris
SWx 2007 SP 3.1SolidworksToolbox







Is there a guide anywhere which explains the steps required to do atoolbox install on a network drive? I want to set a completefastenerlibrary that all the engineers, as well as the shopforeman, can have access to. I know that I have seen somethingsomewhere, but cannot recall where. Any information would beappreciated.
Chris
SWx 2007 SP 3.1SolidworksToolbox