I cannot put my finger on the exact time this started -(install of'07 SP1.1- or - working on this huge project - Onlytwo majorthings I can think of...) - that began playing with thepositionsof the toolbars.

Situation;
I open a part / Assembly / drawing -you name it, any of them,andthe toolbars are Almost Always moved around,shifted,skewed...Basically, not where I left them.
I move the toolbars back where I like them, save, close, openthedocument and toolbars are moved around...again?

Anyone run into this?
-Kutch
SolidworksUser Interface