To raid or not to Raid that is the question?

At my company we are using single hard drives
and over the last year and a half 3 of the 6 have gone bad

each time this happens we have to reinstall all of the softwarewhich takes a day or so after we get the hard drive.

i was wondering if we should go to raid to get rid of down timewhen hard drives go down?

anyone using raid and happy or not happy with it?SolidworksAdministration
Comments 3
DK
DK 2006-12-19
we just had 1 hard drive go bad in our server. we have 6 harddrives. the money that we spent on raid was well worth it. we hadall of our files there, without doing anything. no backup retrievalor anything. it was soo nice.
SF
SF 2006-12-19
I had built our workstations going back some 10+ years andeven to this day when we purchase our Dell workstations we've neverhad a need to configure one with RAID. Yes, we have had drivefailures in those years. But the key it to have a spare drive handyuntil a replacement arrived. Setting up a RAID in yourworkstation(s) is a mixed blessing. If you go with RAID 1 which ismirrored disk you're going to take a slight performance hit but ifone dies you still good to go. If you go with RAID 0 which isstriped you'll get the performance back but you lose faulttolerance (i.e. if one drive fails the entire RAID is lost). Ishould also state we had a file server where we stored all workdone each day for permanent storage and archiving.

The first thing I would do is ask for a drive that's not the sameas the one that failed if possible. 3 of 6 drive over 1-1/2 yearsis pretty bad and I would not want any more of those. I would thengo online and pickup a spare drive and some cloning software. Setupthe spare drive in a workstation and configure it accordingly withsoftware as if it were going to be left in the system. Pull it outand keep it handy. When a drive fails again, you can pop it in andlet the user work. When the replacement drive arrives clone it overand pull your spare.
SF
SF 2006-12-20
I would suggest not to go with raid 0 or 1, i had badexperiencewith this config. My system was crashed and everythingwentaway.

I will suggest that you go  for 2 drive configuration.yousplit the first drive in to 2 partitions, first partition willbefor your system and the second one will be for your SolidWorksorother software, then the other piece of your drive will beyourdedicated drive just for your important SolidwWorks data. youmayuse norton ghost (image /partition) to keep a backup of yoursystemand installed software and keep it in a safe place. if yoursystemcrashed, you can easily restore back your system in a matterof 10min.