A few questions/observations:
1. I cannot get the routing toolbar to appear. PDM Works has takenit over. There are two icons in the "toolbar selection window,"both labeled "routing" and they have the PDM icon next to them.Clicking them toggles the PDM toolbar. Any suggestions on how toget the routing toolbar to appear? I can get the individual(electrical, piping, etc.) toolbars to appear. [There are also 2icons for "edrawings 2007," isn't 1 icon enough?]
2. I have been using the routing component wizard to build mylibrary. I have noticed that there is no way to enter pininformation in the wizard. I have to enter it in when I open thelibrary. It would be nice if I could do this in one step.
3. The routing component wizard does not load configurations of apart into the library. Do I have to enter each configurationseperately?
4. When I open the component library the text in the cells under"SolidWorks Document" appear red. Does this mean anything or isthat the way its supposed to be?
5. The routing component wizard is not inserting clips into thecomponent library. Is a clip not considered a component of anelectrical route? It was in SW'06. Also, the wizard will notrecognize a double clip (like the one that comes with SW).
Thanks in advance for any help, answers, and/or suggestions.
Happy Holidays.SolidworksRouting





1. I cannot get the routing toolbar to appear. PDM Works has takenit over. There are two icons in the "toolbar selection window,"both labeled "routing" and they have the PDM icon next to them.Clicking them toggles the PDM toolbar. Any suggestions on how toget the routing toolbar to appear? I can get the individual(electrical, piping, etc.) toolbars to appear. [There are also 2icons for "edrawings 2007," isn't 1 icon enough?]
2. I have been using the routing component wizard to build mylibrary. I have noticed that there is no way to enter pininformation in the wizard. I have to enter it in when I open thelibrary. It would be nice if I could do this in one step.
3. The routing component wizard does not load configurations of apart into the library. Do I have to enter each configurationseperately?
4. When I open the component library the text in the cells under"SolidWorks Document" appear red. Does this mean anything or isthat the way its supposed to be?
5. The routing component wizard is not inserting clips into thecomponent library. Is a clip not considered a component of anelectrical route? It was in SW'06. Also, the wizard will notrecognize a double clip (like the one that comes with SW).
Thanks in advance for any help, answers, and/or suggestions.
Happy Holidays.SolidworksRouting