Did I miss something in "What's New in Solidworks" or didroute sketch relations change? I used to add a fitting and the 3Dsketch path would snap along x, y or z.
Now I get a collinear and/or parallel relation depending on thepipe fitting. This is not the most critical issue I've encounteredwith SW 2009 but I liked all my 3D sketchs being defined in thethree coordinate directions if I so desired.
Thanks in advance for any feedback...SolidworksRouting
Now I get a collinear and/or parallel relation depending on thepipe fitting. This is not the most critical issue I've encounteredwith SW 2009 but I liked all my 3D sketchs being defined in thethree coordinate directions if I so desired.
Thanks in advance for any feedback...SolidworksRouting