Remove Contact Stresses/Strains from a Plot

I ran an analysis with frictionless contact to simulate aload that changes direction. I don't need the contact stresses andstrains. Is there a way to remove theses? Is there a work around?

The main issue is the max stress/max strain occurs at the contactpoints. I don't care about the stresses at the contact points. Thepart will yield a little at the contact points but this is notimportant. What is important is the stresses caused away from thecontact points. I need to know the max at of all locations exceptthe contact area!SolidworksSimulation
Comments 2
SF
SF 2008-09-01
I would do this by using the "List selected" option in theplot menu.

Right-click on the plot in the feature tree and select "Listselected". Pick the part you wish to interrogate then click the"update" button and this will list the stress at every node on thepart!

By clicking the "value" column header in the table, you can reorderthe values into numerical order with the highest at the top, andwhen you highlight the first row in the table, the location of thepoint will be shown on the model.

You can then down-arrow through the list until you reach the firstpoint that looks like it is in an area you are interested in.

Alternatively, as a quicker but less accurate way, if you try usingthe iso-clipping function (also available by right-clicking theplot in the feature tree) you can move the slider bar to show areasof stress above a given limit and watch for where the first stressappears at a point of interest.

SF
SF 2008-09-02
Hi Jason, in CW Pro (also Adv Pro) v2008, a feature calledTrend Tracker was added. You can use this feature, even on a singlestudy, to isolate specific areas of interest. Create a Tracked Data"graph" for "Max over Selected Entities" selecting only thefeatures/faces that you are concerned about and then "SetBaseline". The single point on each graph will be the max valueacross those entities.

This feature has been expanded to Sensors in v2009. Check it out!!!

-- Vince