Rebuild error

Has anyone experienced the rebuild error " Someresultingbodies cannot be identified from the saved information"whenextruding.SolidworksGeneral
Comments 4
SF
SF 2007-08-27
Mike,

I have never seen that message. What are you doing and can you postan example?

SA
CC
CC 2007-08-27
Yes, and I vaguely remember it having something to do withcreatingmultiple bodies when it shouldn't have.  As for asolution foryou, I think I would have to see the file.  Wouldyou be ableto .zip the file and upload it to the forum?
PS
PS 2007-09-02
In my experience, this usually happens when editing incontextor when your have rolled back some data which is incontext and thefeature has not resolved or will not save because it the data isincomplete?
I don't have a fix for you... sometimes I roll up, roll back,...and re-open the window to see if it resolves so I can save... andsometimes it works,...?
SF
SF 2007-09-05
I've seen this one during split and cavity commands where achange causes the command to produce a different number ofresulting bodies. This is particularly and issue when you specifywhich bodies to keep following such a command.