Processor limitation simulation errors

We have been trying to run a simulation on a large rack for acouple of weeks now and have had nothing but problems. Our hardware specs are as follows:

Dell T5400
Intel Zeon Quad E5430 2.66Ghz
16 Gig Ram
64 bit vista

During the meshing phase if you look at the task manager theprocessor is limited to 13%. It has never gone above this no matterwhat size model we try. Are dealer has not been able to figure thisout. This is our largest customer and they are not happy with us atthe moment.

Can anyone help?SolidworksSimulation
Comments 6
SF
SF 2009-02-28
how big is the problem?
what mesher did you use?
what solver?
What type of analysis?
Is it a mixed mesh? What element types?
What version are you using?
Some relevant info would is helpful when you are asking for freehelp.
SF
SF 2009-03-06
It seems that SW is using only one core (or something likethis) making true the information that it doesn't take anyadvantage os multiple processor/core systems....
SF
SF 2009-03-06
Guys,

If you have your problems set up correctly it works fine but itonly uses multiple cores for invertingthe stiffness matrix. If yourproblem involves a lot of contact interations that are notconverging because the problem isn't set up right then it will looklike it doesn't use them. Ihave been doing this sort of thing withthis tool for over 10 years - it does use them.
SF
SF 2009-03-06
I totally agree with Bill. When you are dealing with contactanalysis and your process gets stuck means you didn't set upcorrectly the study.
SF
SF 2010-10-15

I have the same hardware you do and I believe that your mesher isnt using all of your CPU on one core (seems only half) is that vista uses superfetch and fills your ram up. I believe that the mesher is doing so much that it can't dump the ram and then fill it back up. When you are looking at your performance look at the amount of free ram and cached. If you have no free ram then it must dump the cached ram and then use that newly empty RAM. I have turned off superfetch on my machine and told windows to clear the ram everytime I shut down. It takes a while to shutdown (15 min or so) but i get a clean slate when I reboot. Hope this helps, it did for me.

SF
SF 2010-10-15

My other post may have missed the mesher part of the original post - the mesher does only use a single core - at least up to 2010.