Problem setting up Standard Libraries

Hi, please could someone help with the following problem?

I am in the process of setting up PDMW Workgroup and having troublegetting our standard parts set up properly. The standard partsfolders are on a network drive and I am trying to set it up so theyare not checked into the vault and are listed in the bluehighlighted Library Components folder in the Vault view.

There seem to be 4 aspects to the problem as far as I can see, andare as follows:

==
1
==

When I add folders the Standard Libraries list in VaultAdmin I getthe following error:

"The vault computer is unable to see this folder. Share this folderwith the vault computer to enable the eDrawings preview and opendocument commands for references that are not checked into thevault."

==
2
==

Despite the above error message, the folders still appear in theStandard Libraries list and appear in the vault view under LibraryComponents, but are displayed as "Standard Library References-1","Standard Library References-2" etc.

==
3
==

Parts that are in the standard parts folders do not appear underthe Library Components and can still be checked into vaultprojects.

==
4
==

Standard parts that have been created from Solidworks toolbox partsand are stored in the networked standard parts folders cannot bechecked into the vault and appear in the Toolbox References sectionof Library Components.



If anyone has had similar problems of knows how to get around mineI would appreciate the help. Also, if anyone is willing to post ascreenshot of a correctly set up Vault showing how the standardparts are listed that would at least show me what I am aiming for.


Many thanks for your help,
JackSolidworksWorkgroup Pdm