I had a lot of problems with sw2008, working with Weldments.

I reported them to solidworks, but the same problems are in all newsp

I am working with sw2008 1.1 because I need they repair next bug

1- make a weldment file.
2- make a structural element on a curve
3- make a linear pattern of this element.
4- cut the first element
5- make cut list

You can see that sw2008 2.0 and next sp lose lenght of patternelements but not lenght of first element (second in the cul list).

However it is ok with sw2008 1.1

There are more bugs with weldments.

I think that they must to pay attention to weldments.SolidworksGeneral