Multiple page weldments

I have large chassis weldments in which I have a drawing w/ my views and sections of my chassis and then I run a cutlist on a second sheet of the same drawing file. what sometimes happens to me though is that when I bubble the main drawing sheet the numbers that come up are not the same numbers that are in my cutlist... This as you can imagine is frustrating. this usually works fine when the cutlist is first created but then messes up after changes are made during the checking and approval process. Has anyone come across this? Any fixes?

Thanks

AlexSolidworksWeldments
Comments 6
SF
SF 2008-10-08
My first thought would be that your configurations are not jiving. Your cutlist is generated off of the as welded cutlist and so if you balloon something that is on the as machined config but is different in some way on the as welded it will screw your cutlist up.
JL
JL 2008-10-08
You might also insert a cut-list on every sheet and just hide it - that way it still uses it for balloons yet it is not visible....
SF
SF 2008-10-08
John

Maybe I am missing something but I am not sure what the benefit of that would be. I have made weldment drawings that are 40 pages long with only one cutlist and every balloon is still tied to the single cutlist.
WD
WD 2008-10-08
Does a weldment and cutlist work like an assembly and a BOM? Meaning on the view on the second sheet can you go to the properties of that view and select "link to cutlist" much like you would link a drawing view to an assembly BOM? Just a thought.....or how about a ctrl-Q
AL
AL 2008-10-08
I have tried linking in the past but it does not seem to work as effectively as in a BOM however making sure the "as welded" "as machined" configurations are not being mixed up seems to be working so far so thank you for that, should have thought of it myself... oops... here's hoping it continues to work

Alex
AL
AL 2009-11-20
Thank you that makes sense I will check it out and see what happens

Alex