Hey folks,
I read this somewhere but now forget, and I could not find thisthrough a search, I would like to move the cast shadow to the planeso that the model does not look like it floats. This may be aRealView questions but am not sure, any thoughts??
SW2007 sp4.0
NOTE: I found this in the knowledge base (S03899), but am suresomeone had a solution better than this answer: the shadow iscontrolled by the part or assembly's bounding box. The bounding boxhas six sides, and the shadow is placed on whichever side isclosest to the (on-screen) bottom of the part (whichever way thepart is orientated on screen) when the shadow is turned on.
It is not possible to modify any parameters to change the positionof the shadow.SolidworksGeneral







I read this somewhere but now forget, and I could not find thisthrough a search, I would like to move the cast shadow to the planeso that the model does not look like it floats. This may be aRealView questions but am not sure, any thoughts??
SW2007 sp4.0
NOTE: I found this in the knowledge base (S03899), but am suresomeone had a solution better than this answer: the shadow iscontrolled by the part or assembly's bounding box. The bounding boxhas six sides, and the shadow is placed on whichever side isclosest to the (on-screen) bottom of the part (whichever way thepart is orientated on screen) when the shadow is turned on.
It is not possible to modify any parameters to change the positionof the shadow.SolidworksGeneral