Hi
I'm trying to draw a micro-resistor beam which has total dimensionof about 4x3x25um in size. I've set the units in documentproperties to microns but when I start sketching lines of a fewmicrons in length they don't get displayed right.
Often the lines disappear, even though I know they are still therebecause if I hover the mouse over where they are they gethighlighted so that I can see them briefly. Also when I exit thesketch I can see the endpoints but not the lines!
The dimension units are the only thing I have change so is thereanything else I should be changing for drawings on this scale?
The problem seems intermittent because sometimes the lines are okand sometimes there not and sometimes only a few of them aredisplayed!
Thanks,
sbSolidworksSketching
I'm trying to draw a micro-resistor beam which has total dimensionof about 4x3x25um in size. I've set the units in documentproperties to microns but when I start sketching lines of a fewmicrons in length they don't get displayed right.
Often the lines disappear, even though I know they are still therebecause if I hover the mouse over where they are they gethighlighted so that I can see them briefly. Also when I exit thesketch I can see the endpoints but not the lines!
The dimension units are the only thing I have change so is thereanything else I should be changing for drawings on this scale?
The problem seems intermittent because sometimes the lines are okand sometimes there not and sometimes only a few of them aredisplayed!
Thanks,
sbSolidworksSketching
