lines on top of lines

When there are lines on top of lines, ie when sketching orimporting autocad drawings or dxf's.

Is it possible to delete or select the one underneath.

In autocad you can scroll through the entities in the same locationby holding down the ctrl key. Is that possible here, I have beentrawling through the postings but I haven't come acrossanything.SolidworksSketching
Comments 4
AW
AW 2007-08-01
After selecting a line and doing a right mouse botton (RMB),invoke Select Other in the RMB menu that pops up. From there youshould be able to cycle through the lines.

Cheers,
SF
SF 2007-08-01
Something else I have used is to right click and select chaintochoose all the lines that are connected, then right clickandinvert selection, which should highlight anything notconnected.
SC
SC 2007-08-01
You could, also, just remove all the lines and redraw one tofit. Sometimes all those lines don't exactly have an end point.

Steve
SF
SF 2007-08-07
if you've got AutoCAD 2000, then prior to importing yourdrawing into Solidworks run the Overkill express tool. This willremove duplicates, partial, duplicates, the whole nine-yards.
I love this tool.
Another good one is Mpedit, which will turn a selection set intoclosed polylines (if you supply the close option).
Finally, move your drawing geometry to the origin. Solidworksdoesn't read the insbase system variable.
In short, take care of your drawings in AutoCAD before you importthem into Solidworks
Good luck
John