I have drawn a part with a circular pattern which calls for acertain amount of instances, I have made one drawing where thisinstances count I have dragged into a table, thus if we change theinstances the table will reflect this. Now we have drawn a secondpart using the same methods and cannot get the drawing to importthe instances, I used ANNOTATIONS/MODEL ITEMS/clicked offINSTANCES/REVOLUTION COUNTS from DIMENSIONS box, then used sourceas entire model. In the first case the instances count showed up onthe drawing, now we cannot get this to happen again, not sure whatwe are doing wrong. We are using SW2007SolidworksDrawings And Detailing