Hi.
I`m trying to import a dxf from jetcam. I`m trying to make a3dpart from a 2d dxf that we use for machining the part.
But when i import the dxf into a part sketch i getalotof open counturs.
How do you make the sketch a closed countur so i can make asheetpart from it?
Corner trimming is a bad idea as the sketch contains manyshapes,and it will take forever. Probably be quicker to redrawthepart.
I`ve tried setting merge point on import to 0.1 mm withoutanyluck.
There must be an easy way.
Anybody???SolidworksSketching
I`m trying to import a dxf from jetcam. I`m trying to make a3dpart from a 2d dxf that we use for machining the part.
But when i import the dxf into a part sketch i getalotof open counturs.
How do you make the sketch a closed countur so i can make asheetpart from it?
Corner trimming is a bad idea as the sketch contains manyshapes,and it will take forever. Probably be quicker to redrawthepart.
I`ve tried setting merge point on import to 0.1 mm withoutanyluck.
There must be an easy way.
Anybody???SolidworksSketching
