Why aren't "professional" graphics cards that don't need to have the driver-enabled hardware accelerated edge tracing not being tested for the direct3d application Visualize?
SF
SF2020-01-13
Max;
As for the decals, you're asking Visualize to perform a task best suited for photoshop, and in my experience, it's good practice to simplify EVERY task given to this software....I have the ulcers to prove it.
It's less of a problem these days, but in older versions of Visualize, re-imported models would literally be pasted into the old model, causing a weirdly fragmented pixelated geometry, the telltale result of "Z fighting". I suspect the same thing is happening with your decals: superposed surfaces screwing up the ray-tracing maths.
With normal model surfaces, you could eliminate Z-fighting by slightly offsetting the depth of one of the models relative to the other. Unfortunately, this is not possible with decals; they are mated to a surface (by definition) and cannot be displaced in depth, making z-fighting inevitable and unfixable.
Here's a crappy solution: create new circular plane models, paste on your decal, and move the assembly into place. Repeat until "target" acquired. Better yet, build your decal elsewhere.
As for your cards, Visualize doesn't care about Solidworks certification.
RB
RB2020-01-13
Regarding #1 and decals.. I'm not able to reproduce this. Are you by chance applying any appearances to the decals that are either Emissive, Flat or Multi-Layer? Some different things occur in these cases.
Regarding #2. Can you confirm in 2020 what your System Info shows you? Help --> System Info.
Regarding Queue not working in 2019, you should try stopping and restarting the Queue service from Services tool in Windows.
First of all, you probably know that Nvidia GTX 980 is not a SOLIDWORKS certified graphics card.
SOLIDWORKS Hardware Certification | Hardware & System Requirements | SOLIDWORKS
Why aren't "professional" graphics cards that don't need to have the driver-enabled hardware accelerated edge tracing not being tested for the direct3d application Visualize?
Max;
As for the decals, you're asking Visualize to perform a task best suited for photoshop, and in my experience, it's good practice to simplify EVERY task given to this software....I have the ulcers to prove it.
It's less of a problem these days, but in older versions of Visualize, re-imported models would literally be pasted into the old model, causing a weirdly fragmented pixelated geometry, the telltale result of "Z fighting". I suspect the same thing is happening with your decals: superposed surfaces screwing up the ray-tracing maths.
With normal model surfaces, you could eliminate Z-fighting by slightly offsetting the depth of one of the models relative to the other. Unfortunately, this is not possible with decals; they are mated to a surface (by definition) and cannot be displaced in depth, making z-fighting inevitable and unfixable.
Here's a crappy solution: create new circular plane models, paste on your decal, and move the assembly into place. Repeat until "target" acquired. Better yet, build your decal elsewhere.
As for your cards, Visualize doesn't care about Solidworks certification.
Regarding #1 and decals.. I'm not able to reproduce this. Are you by chance applying any appearances to the decals that are either Emissive, Flat or Multi-Layer? Some different things occur in these cases.
Regarding #2. Can you confirm in 2020 what your System Info shows you? Help --> System Info.
Regarding Queue not working in 2019, you should try stopping and restarting the Queue service from Services tool in Windows.