Hi,
Not to sure if this is the right place to ask this, if notcan anadmin move it to the correct section.
I have been using Solidworks for many years, along withPro/E,Euclid, MDT etc. What I would like to ask is this:
Is it possible to force a user to enter various custompropertiesthat I have set within the part and drawing templatefiles whenthey create a new document. This was easy in Pro/E, but Icant seemto figure it out in Solidworks.
The version I am using is 2006.
Thanks in advance
Ian HootonSolidworksGeneral




Not to sure if this is the right place to ask this, if notcan anadmin move it to the correct section.
I have been using Solidworks for many years, along withPro/E,Euclid, MDT etc. What I would like to ask is this:
Is it possible to force a user to enter various custompropertiesthat I have set within the part and drawing templatefiles whenthey create a new document. This was easy in Pro/E, but Icant seemto figure it out in Solidworks.
The version I am using is 2006.
Thanks in advance
Ian HootonSolidworksGeneral