DXF/DWG Import

Ok, I have no idea if this is even in the realm of possible,but I have been bashing this around for what seems like forevernow, and decided i should just ask...so here goes.

One of my biggest pet peeves with Solidworks, is that when youimport a DXF/DWG, it doesn't keep the name. on average we importabout 200 files a week coming from customers, so this is aconsiderable problem. I have been trying to get Solidworks to addthis ability, but yet to no avail.

Does anybody have any possible ideas as to a solution or workaroundfor this?

Any assistance provided would be greatly appreciated.

Thanks

DentenSolidworksApi macros
Comments 3
SF
SF 2008-11-21
Very easy to do. Create a program that accepts DXF/DWG filesand then runs the SW open file and saves the new file with the DXFname.

If you would like I can modifyBatchProcess to be ableto do this as a little Tool?
SF
SF 2009-05-07
Maybe you guys can help. We just switched to SW. We arehaving terrible time with dxf/dwg file issues when usingSolidWorks. All of are Legacy 2D CAD files are being converted todxf files and all 3D to stp214 files. If I open one dxf or dwg filein SW draft file it will take 14 minutes just to change all of thegeometry to black. I don't have the ability to move the filebecause the dimension will not move with. I does work better tobring the dxf file in as a block butt here are issues with that aswell. I can not beleive the SW is this bad with a smalll 1200KB dwgfile. I have done the diagnostic test on my compyuter and it cameout fine. Is this normal to have very slow performance with dxf anddwg files ? Thanks.

Computer Dell 390
Graph Card FX3500m


SW 2009 Service pack 1
SF
SF 2009-05-08
I always experience extremely poor performance on importing2D data from DXF/DWG files.

Since using 2009 it seems quite a lot better. Perhaps uploadingsome demo dxfs for testing and we can report our speeds ofconverting the files for comparison?