I am running a network toolbox with SW 2008 SP5.0. All thefiles have been set to read only and I have the "createconfigurations" option checked in SW.
I am trying to add a bolt that is already in an assembly. When idrag the bolt in i get a message saying "a document named "sockethead cap Screw_AI" is already open. Do you want to show thealready-opened document". If i click yes it bring up theconfiguration window but only allows me to create one instance. Ifi click no it says "drag and drop failed" If i highlight any boltsin the left hand window it says "in use by system". I have triedthis with mutliple assemblies and am experiencing the same problem.
I exited out of SW completely and had someone else open theassembly and drop the bolt in, worked without a problem. If hehighlighted the bolt in the left hand window it says in use by myuser name, even though i completely exited out of SW.
Can anyone offer any assistance.
I might also add that the toolbox was working fine last week...?????SolidworksToolbox
I am trying to add a bolt that is already in an assembly. When idrag the bolt in i get a message saying "a document named "sockethead cap Screw_AI" is already open. Do you want to show thealready-opened document". If i click yes it bring up theconfiguration window but only allows me to create one instance. Ifi click no it says "drag and drop failed" If i highlight any boltsin the left hand window it says "in use by system". I have triedthis with mutliple assemblies and am experiencing the same problem.
I exited out of SW completely and had someone else open theassembly and drop the bolt in, worked without a problem. If hehighlighted the bolt in the left hand window it says in use by myuser name, even though i completely exited out of SW.
Can anyone offer any assistance.
I might also add that the toolbox was working fine last week...?????SolidworksToolbox