I have reused the subassembly explode steps and explodesketches in the top assembly and the sketches keep dissappearing.
Is there a way to fix that without drawing another explode sketch?
Thanks.SolidworksAssemblies





Is there a way to fix that without drawing another explode sketch?
Thanks.SolidworksAssemblies

But I forgot to say in the first post, the sub-assembly explodesketch will not show up in the drawing views either.
They don't show up in the drawing after the rebuild?
I've had problems with lines disappearing in drawings before, butit was back on '05 I believe. In these instances, it was just amatter of rotating the assembly by maybe 1°.
I'm pretty sure that you can't access the 3D sketch in the drawingview so, for this, I'm at a loss...