I have a design table that worked with 2008 but does notfunction correctly with 2009. I am using a sweep/twist along a pathdefined by turns. This appears as an angle (one turn = 360) in thedesign table. In the 2008 version of this table I could have avalue greater than 360. Attached is the part file of the springwith design table. Does anybody have a solution or have this sameproblem?
I have looked at some spring design macros and these are morecomplicated and larger than needed.
Thanks!SolidworksConfigurations design Tables
I have looked at some spring design macros and these are morecomplicated and larger than needed.
Thanks!SolidworksConfigurations design Tables