I started with a part that had many configs. I did a save aswith a new name to create a new part I then deleted all configs.Now every time I open the drawing to this part I always get thismessage:
"The following component configurations could not be found."
"(xxxx-xxx : part description)"
"If the configuration was renamed the same configuration will beused, otherwise the last active configuration will be substitutedin each insyance."
Any suggestions?
T.I.A.SolidworksDrawings And Detailing
"The following component configurations could not be found."
"(xxxx-xxx : part description)"
"If the configuration was renamed the same configuration will beused, otherwise the last active configuration will be substitutedin each insyance."
Any suggestions?
T.I.A.SolidworksDrawings And Detailing