Bends

I have a sheet metal part that is bent into a basic Z withe90 deg. corners as opposed to the 45 in the letter. I ham trying totake the flat part and bend it in to the formed view. It is a 2 x 3metal tube with two V cuts on either side where it will be bent. Ican get one side to bend at the 90 but not the other. Anysuggestions on what to do. I am using SW '07 SP1.1

Matt
SW'06 SP 1.1
AMD Opteron 175
ATI FireGL V5100SolidworksParts And Features
Comments 8
GD
GD 2006-12-28
Matt -
I'm not sure that I understand your question. The attached is myinterpretation of what you described. In order to unfold the part,one of the 90° corners is going to have to be closed with aseparate part (i.e. a welded assembly).

Why are you trying to insert bends instead of drawing the finishedpart and then unfolding it? I've found that, in general, the sheetmetal part is much easier to edit when revisions are needed if youmodel it in the formed state from the get-go. That's the way Imodeled this example.
SF
SF 2006-12-28
Here Is the part that I am trying to put the bends in thismight clear up the question a littles bit

Matt
GD
GD 2006-12-28
My workstation thinks there is something wrong with the zipfile that you posted (blocked by XP because of harmful content).

How about posting a jpg?
SF
SF 2006-12-28
Matt,

Do not know what you used to zip the file but when I open it, thereare no files inside.

SA
SF
SF 2006-12-28
Here is theflat and formed views. Currently they are drawnsepertally. But we would like to combine them.
SF
SF 2006-12-28

SolidAir wrote:

 

Matt,



Do not know what you used to zip the file but when I open it, thereare no files inside.



SA

I used the Pack and Go feature in Solidworks.
GD
GD 2006-12-28

Matt Halfmann wrote:

 

Here is theflat and formed views. Currently they are drawnsepertally. But we would like to combine them.

This isn't exactly what you were looking for, but it is asheet metal part that unfolds to resemble a notched tube. Imanually suppressed 3 of the bends in the Flat-Pattern1 to keep thepart from completely unfolding.

SF
SF 2007-01-02
Matt,

I am back at work this week and did some research into why I couldnot see any files when I opened your zip file using windows.Apparently, Pack and Go uses a different algorithm that is notcompatable with windows. I could not see any files using Windows(Compressed Folders) at work either. I had to use winzip and thenhad no problem extracting your example.

SA