Welcome back to the User Forum modeling challenge series!
Last time you folded a camp chair.
This time, we’re heading to the kitchen, just in time for USA Thanksgiving. 🦃
MISSION Model for Me #4: The Pop-Up Turkey Timer
On the surface, it’s a little plastic stick you jab into a bird. To a talented SOLIDWORKS pro (you 😉), it’s a spring under compression, a trigger that lets go at exactly the right moment & a plunger that has exactly one job. Get one clearance wrong & your timer pops at 9 a.m. Get one spring wrong & your dinner guests are eating dry turkey. 😭
Challenge Overview
- Model a pop-up turkey timer in SOLIDWORKS as a working assembly.
- It must have a real compression spring (the Spring feature or a helical sweep), not a “spring-ish cylinder.”
- It must actually pop using real mates & a motion study. If it only works because you dragged the plunger up by hand, we’ll know.
Key Design Features to Capture
- The Housing: A plastic body with a pointed insertion tip, a vented window & a clean draft. Bonus points for a believable shell, ribs & fillets.
- The Trigger: A heat-sensitive pellet or latch holding everything in place. How you represent “melted” vs. “not melted” (configurations, display states or a simplified stand-in) is part of the challenge.
- The Spring & Plunger: Compressed at the start, released at the end. Watch your free length vs. working length.
- The Pop: The plunger must travel a believable stroke & stop at a hard limit.
- The Details: Retention barbs, a cap, a stem. Little parts, big impact on whether the thing moves.
The Tiers
Which level dare thee?
- Bronze - “Stick It In”: Complete assembly with the timer in the set position (spring compressed). Include a section view that shows the trigger & spring.
- Silver - “Pop It”: Everything in Bronze, plus a working set → popped transition using proper mates & a motion study.
- Gold- “Done Means Done”: Everything in Silver, plus a thermal study in SOLIDWORKS Simulation showing the trigger tip heating through a turkey breast (your own simplified solid) until it reaches your chosen trigger temperature.
The Guidelines
- Model it: Use the photo as reference, or bring your own favorite timer. (Yes, you may dissect one. Dinner is hours away.)
- Show the Logic: Post your final model & your Feature Manager tree. We want clean design intent, not a “geometric nightmare.”
- Show the Motion: Silver & Gold entries must include a screenshot or short clip of the pop.
- The Signal: Tell us the one feature that was surprisingly difficult to get right.
- Software: Any version of SOLIDWORKS.
- Spoiler Tags: If you share step-by-step hints in the comments, please use spoiler formatting.
What was your biggest hurdle: the spring, the trigger logic, or getting the plunger to pop without flying off into the next dimension? Did you drive the whole thing from a layout sketch, or build it part by part?
Those daring Bronze, Silver or Gold, we want to see your ideas & creations! Share your work below and to those celebrating Thanksgiving in the USA: enjoy!
<strong>Notice:</strong> By participating in this challenge, you acknowledge that pop-up timers are known to pop early, pop late & occasionally not pop at all. SOLIDWORKS is not liable for any user-generated dry turkey, uncooked turkey or awkward silences at the dinner table. If you can’t handle the heat, maybe stick to modeling something safer... like a cranberry sauce can.