Hi All. Our company uses SW routing for lots of piping and tube routing. When creating our standard library I've noticed the CPoint property of "minimum straight length". I assume this intended to specify a minimum straight length that is required before any bends or other fittings which is exactly what I want to specify; however other than setting a value. I've never seen it used anywhere. I can set a minimum straight length of 15 mm for a fitting's CPoint but when I use the fitting in a route, if I reduce the straight length to 10 mm I get no warnings or errors.

Is there some functionality that I'm missing? It seem as if it's just an unused property to me. Does the value entered here make a difference anywhere?

Thank-you for your assistance.