Is anyone else experiencing trouble with the isolate viewcommand? Recently I am finding that after completing a save, anyisolated components reappear even though the isolate toolbar isstill functioning. I have to click the exit button and then reisolate.
When saving, any isolated parts have always reappeared buttypically for only a second or two and once the save is finishedthey used to dissappear again. The problem has only appeared in2009, I think it started after upgrading to SP2 (i'm on 2.1 now)
I have a workaround (create a display state) but I would like toknow if this problem is down to me or not.
I am also finding that the problem does not always occur, I startedan RX to send to my VAR for Monday and it decided to behave itself.A little later it started playing up again.
I am using an ATI 7200 FireGL card and I'm wondering if this is theculprit. it does seem to have a few foibles when running SW.
ChristianSolidworksGeneral
When saving, any isolated parts have always reappeared buttypically for only a second or two and once the save is finishedthey used to dissappear again. The problem has only appeared in2009, I think it started after upgrading to SP2 (i'm on 2.1 now)
I have a workaround (create a display state) but I would like toknow if this problem is down to me or not.
I am also finding that the problem does not always occur, I startedan RX to send to my VAR for Monday and it decided to behave itself.A little later it started playing up again.
I am using an ATI 7200 FireGL card and I'm wondering if this is theculprit. it does seem to have a few foibles when running SW.
ChristianSolidworksGeneral