Hello everyone,

I have a problem with Solid works 2013 toolbox standers.

The toolbox is empty as in the attached photo [4].

I got the message "The toolbox has not been configured configure now ".

Then from "Options" under "Hole wizard/ Toolbox", I selected "configure", I got the result in the attached photo [1].

For Hole wizard, no problem,  all standers holes are available as in the attached photo [2].

The problem is in the "Toolbox standers" as in the attached photo [3]. It is empty!

Does any one have a solution for this problem.

Thanks in advance

Abd El Khalick