Sweep Problem is kicking my butt.

AAAAAHHHHGGGGGGG.....!

I have never had to give up on building a model - but this one is killing me.

Need to make a profile follow two guide curves into two solids.

It's just a wench - but it has a lot of radius blends in a small area.

I tried to simplify the sweep profile on the first two. The first uses just one guide curve.

The third one has the profile as it needs to be - but you can see it falls short.

I have modeled a similar part, but bigger and it would work - is my problem the fact the radius blends down to zero then stops the sweep....?

What other way could I model these shapes....?

If I extruded the full profile - how could I add the .300 Radius on the handle area face....??

Any help or advice would help

Thanks in advance.

Rich

SolidworksParts And Features