We are at the renewal stage of subcriptions and I really don't think we should pay.

Pdmworks is still broken, as we can run the vault service on one of our servers, but not the vault admin tool.

This is because Solidworks did update the vault to work but could not be bothered to update the vault admin tool!

All attachments do not check out of the vault as they have lost their links to what they were attached too.

The reg settings are set to validate the vault on a restart and so this is not the reason. We can not use the Vault admin tool to change settings for the reason mentioned above.

Pdmworks is still broken, as we still can not see the parts used in an assembly by hovering the mouse over the part.

Pdmworks is still broken, as we still can not choose what configuration we want look at.

Solidworks is still rubbish at remembering table templates and changes them at will.

Apperances still not working correctly.

Unable to put centre marks in some but not all drawings.

The new sheet metal is total rubbish.

Are any of the above going to be fixed or should we just keep our money to cover for the lost time?