I would like to have some more details about how the SolidWorks test works.

I can see that, in the 2014 rankings here: http://www.solidworks.com/sw/support/shareyourscore.htm there are people that could complete the rendering test in less than 10 seconds and somebody could finish in 0.6 seconds.
I also noticed that the test will start in a window if the last session of SW was windowed, otherwise it will start full screen.

I suppose that this test will use the settings that are the last used in the program, so if I set a rendering resolution of 100x100 pixel I should get a 0.6 seconds render time too... Is this right?
Maybe it would be a good thing if it could be possible to run the test at some "standard" settings... What do you think?