Hello everyone,

Let's say I have a panel.  On this panel, I have a bracket that has #4 clearance holes (that were created with the Hole Wizard) to mount the bracket to the panel.  At the time the panel was created, I didn't know exactly where the bracket was going.  Now that I know where it is going, I want to extrude the #4 holes thruough the panel so I can use Smart Fasteners to bolt the two together.  When I make the hole in the panel with the Converted Entities command, the properties of the #4 holes don't come through.  I guessing that is what is happening.  When I put a nut on the screw, instead of mating with the back side of the panel, its matinf with the back side of the bracket.  What is the proper way to do this so things bolt together properly?

Thanks,

Duane