Running SW2008 on non-approved graphic card

All,

My computer is a Clevo notebook, specifically a M57U (same as aSager 5760). The graphics card in this machine is a nVidia gForceGO 7900 GTX. I have the latest drivers installed fromwww.laptopvideo2go.com.

When I work on a part in SW, I get terrible artifacts. Portions ofthe window do not redraw properly, back windows 'leak' through,etc. The problems are bad enough that I cannot use SW.

Since getting a new computer at the current time is not an option,and given that my first try at trying to make my card look like aQuadro failed (would be willing to try again if you have goodinstructions), can you suggest a fix so that I can get some workdone in the near term?

Note that the machine I need to design is relatively simple, sonon-optimal methods are acceptable.

Thanks.
SolidworksGeneral