This is difficult to explain, which is why I took a video.

When I try to edit a feature of a part, I right click on the feature. When I do this, the part outlines itself (in orange lines) very slowly. Normally this happens instantly, but now takes 4 seconds. This happens every time I edit a feature, which adds a lot time to my workday.

I have a (5 month old) Dell M3800 laptop, 16 gb ram, Win 7, Running SW 2011 SP4.0, Video Card is Quadro K1100M

4 other coworkers have the same laptop and haven't seen this issue.

I have tried taking coworkers setting and installing them. It solves the problem for a day and then this pops up again. I have done SW RX and cleared out files.

Any other steps I should try?

thanks for the help

Don