Hi there, 

I'm looking to design some parts and perform FEA analysis similiar to how the Plastic Injection Simulations under the Plastics module operate. I want to review an existing design to determine if there could be any issues (low-fill, air pockets, over cuts, etc) before the molds are all created - the same benefits that performing injection molding simulations can benefit for the plastics. 

Understanding that there are key differences in RTM vs IJ, but also that there are many similarities. There are specialized software packages for this (i.e. RTM Worx) - Any thoughts on how best to assess a part's suitability for RTM in Solidworks? 

TIA!