Prescribed Displacement With Internal Reaction Forces

I'm trying to analyze some components of a hydraulic lift table. I'm in the process of running a nonlinear assembly analysis with a prescribed displacement. I input the displacement as a fixture on one "ear" that the hydraulic cylinder will connect to and specify a displacement relative to some plane. However, doing it this way doesn't give me the reaction forces  that would be felt on the other side of the hydraulic cylinder.

Can anyone help me find a way that I could do this analysis more accurately?

SolidworksSimulation
Answers 5
RD
RD 2018-04-23 Best Answer

Hi Andrew,

The description of your setup doesn't make total sense to me.  Do you have a model of your setup and/or some pictures of what you are referring to here?

AM
AM 2018-04-24

The hydraulic cylinder is excluded from the analysis, and I have modeled some pins where it would otherwise be. I can use a prescribed displacement on the top pin (as shown) to have it move in a direction that the cylinder would. But, I can't simulate the reaction forces that the cylinder would apply to the lowermost pin. (Not shown are all of the contacts that I've applied to simulate the effect of the lift arm pins and rolling elements.)

I could use applied forces instead of prescribed displacements as an alternative. I was hoping prescribed displacements would just tell me the forces involved, however, rather than just using the maximum cylinder force that it can generate.

comment imagecomment imagecomment imagecomment image
BS
BS 2018-04-24

This looks to me more like a problem for SolidWorks Motion rather than FEA.  If all you need is reaction forces as a result of assembly displacement, Motion will solve much faster than a nonlinear FEA.

RD
RD 2018-04-24

Yes, you could only measure a reaction force where you have the prescribed displacement defined.  I expect that the force in the prescribed displacement would be equal and opposite on the other mounting pin hole.  You might just run the study you have with the prescribed displacment, measure the resulting force on that fixture, then apply it as an equal opposite force in a duplicate/follow-up study.  If you want to keep the prescribed displacement this would get you to the point of having loading on both sides of the cylinder so you can at least see the stresses on both ends.

AM
AM 2018-04-24

No, not necessarily. I have an applied load on the table, and I also would like to know the stress in the links and the stress in the beams that support the cylinder while it's being stroked.