Parametric study needs recalculation for newly added results?

Hello,

I tried to use parametric studies to determine the pressure drop over a valve for different mass flows. I expected that parametric studies need less computation time than doing the variants manually.

But I discovered two problems:

1. The computation time for each single scenario is similarly long as the computation time for the original project. Is this true?

2. If I have calculated the different scenarios, and afterwards want to look at a different result parameter (e.g. a velocity...), this newly selected result parameter does NOT appear before I recalculate all the scenarios, needing again the full computation time ! Is this normal, or am I doing something wrong?

Thanks

SolidworksFlow Simulation