Hey guys,

New-again to Solidworks (10 year hiatus.)

I am working on a 2 seat airplane design, so most of my surfaces require lofting. After running CFD in OpenFoam, I would like to move the wing back 2" and down .5". Apparently I still need to work on my organizational and design methods.

The wing is based on multiple sketches, to then be lofted. The sketches are obviously children of other planes/sketches, etc....

Is there a way to move the wing back 2" and down .5?" Can I make is a separate part?

In the long run all my surfaces (fuselage, tail, and wing) will be given thicknesses, then parts will be pulled from those shapes (Bulkheads, brackets, etc)

- Attached is a picture of everything that needs to move 2" aft, and .5" down, in blue.

Thanks guys!