Move Bend Line NOTE and make it stick

I am using SW2011 SP3.

I have a series of drawings where moving the bend note to a new location would be helpful. The problem is that everytime I rebuild and everytime the drawing is opened (which causes a rebuild) the bend note returns to its default location.

I was hoping for an answer that didn't involve retyping the note by hand into a non-parametric note. This is note a critical issue, but I thought perhaps someone else had run into this before.

As an aside, it sure would be nice to be able to link to a bend note in a standard note...

Thanks, Daen

SolidworksDrawings And Detailing