Hello,

I have a macro that allows me to draw a room (large square) with material removals (small squares) on specific coordinates.

>Draw a square of 2.7x2.7mm² and an extrusion of 0.5mm

>Take the coordinates of points (in the input file) then draw the small squares of 0,085mm of side.

When I run the rectangle drawing command with the coordinates (x1, y1) and (x2, y2), I checked and it is the correct coordinate values ​​that are sent by the macro to SW.

Yet I have errors in the drawing for the components so the values ​​(in absolute) are of the order of 0.0075mm and 0.0125mm.

While it works fine with values ​​greater than 0.0335mm.

My questions

1) How to remedy this?

2) Is this a limitation on the precision between macro and SW?

Attached files. "Input_file.txt"; "Macro.swp"; "Room.sldprt"   (SW2017 / VBA7)

Thank you in advance for your return.